Earthpig

I’ve been thinking of putting together a Domina 9 upper on a Limited Custom frame to run in open Division. Everything I read is problems with the Magazines. Any thoughts? Guidance. Etc. Ive own 7 Tanfos, production, Limited, Carry Optics. So Im well verse in working on them. Looking for those of you that have done this Olin the past and were successful.

Did you get that holster? If not DM Me I make them for myself and would like a second opinion

Well, I had the same issues. It got fixed by a wolf 13 LB hammer spring and monitor the firing pin spring. Yes the firing spring breaks it does not ignite anything reliably

This happened to me also. Overtravel and pretravel screw had moved. Adjust both sp you have some overtravel and sloght pretravel locktite and problem solved.

I have a few of these also. With the henning firing pin. Use the patriot defense Optimized firing pin spring and the long sear(stoeger proshop) is the one that comes with the gun. The extreme sear works but lota of polishing involved. 14 LB egw hammer spring. If you want ill tell you the entire setup. Also you could remove the firing pin block for Limited. Not necessary if properly set up

The Limited Custom Extreme is ready to go out of the box. 2 3/4lb trigger out of the box and yes, it cleans up to 2 or less. At least that has been my experience. The only thing you need is hennings 140 base pads for 20rd reloadabe.

3.2 or 3.3 @ 1.125. Plunk, spin test. Good load.

Glad to hear that. Enjoy the tanfo

You wont regret it

Dont know w for sure if they tune them. However, I went the way of purchasing a basepad and follower for my mags. Had to modify the basepad to fit the 140 gauge. Then i purchased the complete mags from hennings and they are perfect. Fit the guage, feed correctly, 20 rounds reloadable. I stuck with this route and have not had issues.

Brother, have been there and done that. Look at the Hennings mags for the solution to your problem. What OAL? If longer than factory get the 10mm mags. Call Henning Shop and they will walk you to your issue and give you viable solutions.

That was an amazing job.

Example: 110 dollars in magazines 5Ea 120 dollars on base pads 46 dollars for the Bolo 106 Hennings upgrade kit 40 dollars various springs 924 for the gun grips depends on preference All this for about 1350 and you will have 5 mags to work with which everyone forgets. The S2X comes with 4 mags and all that will have to be added to optimize is the Bolo. It is true you will have to polish certain parts to smooth out the trigger no matter the model you get. I opted to get two of the stock ones and fully optimize. BLUF: S2X is not worth the bang for the buck. Unless the ceramic coating is a must.