4mike

+1 and check if you have instaled blue or red cylinder stop spring

http://www.midwayusa.com/product/869125/wilson-combat-pistol-chamber-brush-45-acp?cm_vc=ProductFinding

I made it twice in the past twice very strong alergic reaction at the wood or wood conservant (grade fever and rash, intravenous corticosteroids and calcium) for the future I will use https://www.cromwell.co.uk/images/product/TFF/962/TFF9623831B_0.jpg

thanks all don't know lifetime of this gun, before repair approx. 80k fired :-) I forgot picture after gap fitting

new bushing + brass punch before assembly, bushing at the center shaft done :-)

I think better way are grind the cam to the S&W design

if your metal cube waddle on the top of the FP bushing itś OK

sorry it look as terrible solution gun shipping from Europe aren´t so easy as across the US

figure does not represent the current state, it's a state before the last shot, after this bushing disintegrated, the rest is to be removed, in the bushing is hole thru in firing pin size. Remains only electrical erosion and I dont know how deep with erosion because dont know how thick are the bushing and what is correct design and sizes of bushing. sorry for my english :-)

Is there somebody with experience with bushing change at 625 ? I have experience only with hammer mounted FP 586 and 686 its same flat design or it is cup ?

http://www.brianenos.com/forums/index.php?showtopic=146065

http://www.brianenos.com/forums/index.php?showtopic=156858

#4 Carmonize :-)

12rnd stage nr1 shooter A 12A 6sec. HF 10 score 100% C 11A 1miss 6sec. HF 5,625 score 75% B 12A 8.5sec. HF 7.058 score 70% (2,5sec reload) 12rnd stage nr2 shooter A 12A 8sec. HF 7,5 score 100% B 12A 10.5sec. HF 5.714 score 76% (2,5sec reload) C 11A 1miss 8sec. HF 5,625 score 75% another, but slower 12rnd stage shooter A 12A 12sec. HF 5 score 100% B 12A 14,5sec. HF 4,138 score 87.7% (2,5sec reload) C 11A 1miss 12sec. HF 3.755 score 75%

using magnetic holder

by my experiences it causes more with B style designed bore in cylinder (for extractor shaft) as guide for file using steel chamber insert with ball bearings for ratchet fitting finish I use old sharpened hands for 586/685 chamber insert with 10mm OD bearings

I think the problem isn´t possibility to shot with cylinder out, but possibility shot with unlocked center pin (by contact of shooters thumb with cylinder latch or some technical problem) I think the design what prevent this failure is part of safety it is similar as 3th pin of the hand

I think he is speaking about marks by non deburred rebound slide

do you need try it, I love mine

it was my comp snubbie taurus m82

+1

I'd buy two (with short cylinder I hope)

no rubber band, superglue at the finger works better