oddjob Posted March 9, 2008 Share Posted March 9, 2008 OK......Towards the end of the down stroke I get a resistance/drag feeling. Took off the primer system and still have the same problem. Took the tool head off and the arm is smooth as butter. Put the tool head back on and its rough again. There are no cases or primers in the 1050 either. Checked what I could without luck. Any ideas?? Thanks. Link to comment Share on other sites More sharing options...
al503 Posted March 9, 2008 Share Posted March 9, 2008 Only things I can think of: 1. you got something stuck in the guide hole(s) 2. your powder bar is sticking Link to comment Share on other sites More sharing options...
D.Hayden Posted March 9, 2008 Share Posted March 9, 2008 On the case feeder.. Make sure the whole case feeder moves smoothly by itself.. check: Case Feeder plunger glides smoothly Check that the bolt isn't bent (#13333) The plunger roller is well greased, and turns smoothly. Link to comment Share on other sites More sharing options...
WillM Posted March 10, 2008 Share Posted March 10, 2008 Just had the same-sounding problem Friday night; kept feeling worse and finally would not return on the upstroke. Kept removing assemblies until I found that the primer punch was bent. Spoke to Dillon on Saturday morning and a new one is on its way tomorrow. Had to remove the rocker assembly under deprime/prime stations to get to primer punch. Link to comment Share on other sites More sharing options...
shred Posted March 10, 2008 Share Posted March 10, 2008 Also can be the primer punch swager is set wrong or the dies have drifted downwards, but the first place I'd check is the priming system linkages-- both the parts under the shellplate and those on the arm. Link to comment Share on other sites More sharing options...
oddjob Posted March 10, 2008 Author Share Posted March 10, 2008 Bolt Part #13333 was slightly bent. Fixed it, greased the plunger area and roller and now she is smooth again. I cleaned the whole thing and checked everything mentioned here. Thanks everyone Link to comment Share on other sites More sharing options...
warpspeed Posted March 10, 2008 Share Posted March 10, 2008 Bolt Part #13333 was slightly bent. Fixed it, greased the plunger area and roller and now she is smooth again. I cleaned the whole thing and checked everything mentioned here. Thanks everyone Aren't we a helpful bunch ? This is one of the things I like most about BE.Com. Have a problem ? you will get 3 or 4 different things you never thought of. Very cool. Glad you got it fixed. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now