wbkr68 Posted March 16, 2017 Share Posted March 16, 2017 While working up some loads for my new stock 2 tonight I noticed that my feed ramp has a sharp little notch on the side of it. If you run finger towards the chamber it feels fine. Away from it and its sharp. Should I take a stone to it? Opinions? Sent from my SAMSUNG-SM-N910A using Tapatalk Link to comment Share on other sites More sharing options...
MemphisMechanic Posted March 16, 2017 Share Posted March 16, 2017 I would. Then polish the hell out of everything back there. More for ease of cleaning than a gain in reliability. Link to comment Share on other sites More sharing options...
wbkr68 Posted March 16, 2017 Author Share Posted March 16, 2017 Okay thanx! I was kind of disappointed to see that. Im surprised it made it through qc.Sent from my SAMSUNG-SM-N910A using Tapatalk Link to comment Share on other sites More sharing options...
ryridesmotox Posted March 16, 2017 Share Posted March 16, 2017 They QC guns at tanfoglio? Could have fooled me. My chamber was out of spec by like a 1/4 inch... Not even lying I couldn't plunk 115 gr Winchester white box Link to comment Share on other sites More sharing options...
NicoR Posted March 16, 2017 Share Posted March 16, 2017 They QC guns at tanfoglio? Could have fooled me. My chamber was out of spec by like a 1/4 inch... Not even lying I couldn't plunk 115 gr Winchester white box I've seen a CZ Shadow with no chamber. No reaming AT ALL! So unfortunately it must be quite common. Link to comment Share on other sites More sharing options...
ryridesmotox Posted March 16, 2017 Share Posted March 16, 2017 That's pretty bad. But I bet CZ would take care of that. My experience with EAA has been, let's be kind, let's say less than ideal. Link to comment Share on other sites More sharing options...
YVK Posted March 16, 2017 Share Posted March 16, 2017 I deleted my photo but it looked identical Link to comment Share on other sites More sharing options...
leemoe83 Posted March 26, 2017 Share Posted March 26, 2017 It's a clearance cut for the extractor. If it is sharp just debur it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now