jstagn

Anyone using a non-captive rod and spring? If so what kind.... Thanks...

I have a M&P 9mm pro 5", accuracy leaves a lot to be desired. Who out there can work their magic for better accuracy?

So, it will do everything a standard Dillion or someone elses will do with regard to checking everything except AOL?

For those of you that have used the Hundo case gauge. What length round AOL,(45acp & 9mm) will fit before it hits the bench that its laying on. Also any negative points?

Thanks ParaGunner................,

Have a 1995 para p14-45, needs new extractor. Friend told me any standard 1911 will work. Any input???

Anyone have a preference for one or the other? Why?

You would think with less powder yielding the same speed as the plated that the Bayou would feel softer, just shows that you have to experiment, with different bullets, powder and even primers and even different guns.

Thanks, have you noticed any recoil differences with the Bayou vs. plated, both making major, since you are using less powder with the Bayou?

Just did a quick comparasion with chrono. Seems E-3 needs about .1 gr less than Clays for the same speed. Will do further testing. Interested to hear from others who have chrono this load. 45acp 230gr xtremme bullets, same overall length and crimp.

The washer was missing and S&W is sending me a whole new rod and spring. THANKS

What little washer?

Thanks Bigfish..................

What about the Burwell mod (blob of weld as its described here) would this be legal for IDPA? Rules seems similar not externally visible mods.

You may be right. So I should just leave the nut/bolt off? Would that make it difficult to re-assemble? Thanks....

I changed out the captive recoil spring from factory 16lb. to a 15lb. works great with Vit n320 3.2gr. The problem is sometimes while cleaning the captive assembly the recoil spring will pop off of the end nut that retains it. Too much lube?

Good observations. Clays seems faster the more temps go up, but I have not seen any figures like the 1% that Vit specifies.

Loaded 230gr 45acp Alliant e3 at 4.3 gr. chrono today at 55-60 degree temps. How does temp affect E-3.

THANKS.............

Chrono 9mm 147 gr. load 3.2 grains Vit N 320 at 55-60 degrees today. How temp sensitive is n320? I know clays gets slower at lower temps.

Have an 1995 Para and had the slide cut years ago for adjustable (rear) Bomar sights, front and rear. Front sight is the tall Bomar blade. Looking to replace front sight only with a Tall Green Fiber Optic that will fit in the Bomar cut. Suggestions??? Thanks.......

try the dawson pads on the mags that work, then you will know if its the mag.

Pulled the 2 pins, toolhead is STUCK will not move even with tapping out with a punch. 45acp has been in there for about 6 months. Help?

If using small primers for small 45acp brass, how will it affect my loads, power factor wise, compared to the large hole/large primer???

Bedell contact info?