I purchased the P-09 guide rod from CGW. They said I would have to trim it down. They didn't say anything about it being to "soft". If possible; can you please tell me why they said this. Is it safe to use with the P10F? Thanks!
I recently purchased the CGW SS guide rod and the 15# flat spring for my P10F. The only springs they have are the 15# and 18# springs. I have not shot it yet. I was wondering if a 1911 round style spring would work in the P10 series of guns? That way it would be easy to go down to 13# or so. Anyone that has some advice, please help! Thank you!
Re: Optics on the CZ P10F
I know of a shooter that started off with Vortex brand. He had many problems. Switched to a Sig Romeo 1. How does the Romeo 1 compare in quality to the others?
I bought 5 Dawson 10 round magazines for my S&W 1911 Pro 9mm. Have not had one feeding issue. They have the competition base pad. I have shot in in USPSA SS division.
I took it to the local Ace Hardware store and found one that fit. Sorry, I don't recall the size. I called CZ USA they said they don't carry those parts. Said I should call CZ Custom.
My Shadow 2 was the same. I shot a Steel Challenge match. I had to aim about 8 inches to the right to get hits on steel. I loosened the two set screws and tapped the sight over. I did strip out one of the set screws. You may want to heat them up before trying to remove.
I have read on this forum that the shock buffer on the recoil spring doesn't show much wear until about 8,000 rounds. The gun comes with a few. I have been running mine with it in until it shows some wear. Then, I am going to put a new one in.
I am almost positive that I am over crimping. I did this originally because I was using a revolver. JM 929. I did this to avoid bullet jump. Thanks for the help!
I am using Summers Enterprises 124gn poly coated lead bullets wit 4 grns of Red Dot. The bullets sometimes tumble (hit the paper sideways). I was told that Red Dot is a "fast" powder that is not allowing the bullet to engage the rifling of the barrel causing the bullet to tumble. I was told to switch powder to Tight Group. Will TG be a slower burning powder that will solve the tumbling issue? Thanks for any help!
I ordered the lighter spring kit with a new firing pin and spring. If I put a lighter hammer spring in; will I have to use the lighter firing pin spring also? Thanks for any help!