Loves2Shoot

We have a CZ Shadow slide in for a direct sight to slide install and from all the measurements, we should be able to mount it directly to the slide without an adapter plate. This will be far be lower. You might be able to actually see the front sight in your case, but I'm not sure about a co-witness.

We have one designed, but I'm not sure when we will be able to make them for production, as the response to our new products has been much more positive than we could have hoped for. Here is the standard sized base pad.

Fresh from anodizing, we have the new basepad versions for those using a SSS magwell. http://shop.springerprecision.com/category.sc?categoryId=25 These are the short version. I'll upload photos of the regular versions tomorrow.

We have a shadow slide inbound so we can make dovetail mounts for them. You can contact us directly for items under $100, or Brownells for items of greater value. They will send us a special request if they do not stock an item we carry.

Yes, comps will be offered as stand alone parts.

.5" past the end of the slide.

5.75"

That looks great, I bet you would sell quite a few if you could build it in a cone style, if all we had to do was to remove our bushing thread our current barrel and fit the comp to the slide I would order one today... :-) I would like to see that also. I would rather thread the stock barrel and fit the comp as an option. I already have a hard enough time keeping XD/XDM barrels in stock.

We will add the RMR and Deltapoint as options for the mount.

That is a compromise for both. If you wanted for minor, you could lop off the last port and go with two. Some people like to added side ports to the last chamber.

I had one of those rigs. It is more a question of design type. I've found that you don't need as much comp for minor. If there is demand for both, then I need to keep that in mind.

Yes, we do if the slide is wide enough and there are no issues with safety locations. We charger $150 for a milled application (plus refinishing if you chose to recoat.) We mostly do Glocks and M&P's as XD's and XDM are too narrow without an adapter plate, and when you add an adapter plate, the cost goes up and you don't gain a lot in height offset.

Yes.

Red Loctite, on the XHM the guide rod doesn't lock into the comp, it just has a clearance cut. I think the next run we do for those, we'll be doing a new profile without the lower lug because a majority of the comps we are selling are for the 5.25.

CZ 75 comp CZ75 Comp.pdf

Not a problem. I need to run some more XDM comps in the near future. For those that are interested in a comp for the 9mm, are you more interested in one for minor or major? I added a poll at the top.

It sounds like I need to order a TS barrel.

I would consider it if barrels are readily available.

I have a Shadow and TS slide inbound.

I should have the first run done in 2 weeks and 1 week is about average for anodizing, so about 3 weeks.

We are going to do the RMR. You would need to send the STS in, but we could do that also.

That would be great. We only need it a few weeks.

We need other slide profiles to add the other versions, so if you are interested in a mount we don't have and can send a slide in, we would like to add the other CZ dovetail models.

Per customer request, we added the CZ75 to our scope mounts. We are starting out with the Burris/Docter base profile. http://shop.springerprecision.com/product.sc?productId=261&categoryId=42

Nice, I like the look of those grips too.