Loves2Shoot

We do all the major profiles and can do an oddball one if you send the scope in.

We will add one for the shadow also.

We will add the DeltaPoint after the FFIII.

There is a PDF on page 1 of a preliminary design. No dates yet.

Look up a few posts http://shop.springerprecision.com/category.sc?categoryId=42 They are available.

For the Kadet, use the Shadow mount, NOT the CZ75 mount.

We found out that our Shadow mount will work for the Kadet also.

E-mail sent.

Bottom view.

This is a one piece aluminum sight base for the CZ75 Shadow pistol. It uses the rear dovetail to mount the sight to your slide. Hard anodized for a long service life, we also added polymer tipped set screws fore and aft to our mount to make the sight mount much more stable than other designs. It also has a cutout so that you can remove the extractor pin with the mount attached to the slide. http://shop.springerprecision.com/product.sc?productId=265&categoryId=42

Shadow Fastfire mounts are in. http://shop.springerprecision.com/product.sc?productId=265&categoryId=42

Yes, we can cut any metal slide that has room to do so.

Hardchrome is thick and it takes awhile to wear through it.

They should be available the end of next week if the anodizer holds their schedule.

We have the Deltapoint slide mounting milling program set up for the Shadow.

We added a hole on the Shadow mount so that if you need to pull the extractor, you just need to remove the scope and not the mount.

Then you should be ok. I think it will hand over just a tad on the DP.

Very nice !! That must be tough deciding out how far forward or back you place the platform relative to the dovetail? ... it's hard to tell in the picture, but is the front of the platform covering the extractor pin hole on the top of the slide? If so, seems like you'd want the platform to shift slightly rear-ward so sight platform removal isn't necessary whenever you need to remove/service the extractor? So enough clearance to access the hole/pin with a punch. That is determined by where the holes are for mounting the scope the plate and the dovetail set screws. You would need to remove the scope to service the extractor.

So you think with the DP it won't hinder lowering the hammer by hand? Also instead of rear irons a center notch can be laser etched into the body of the DP at the rear and the proper height front sight to line up as BUIS. It would make it more difficult, especially if you have large hands. You might have to pinch the hammer from the sides.

Says just about every B class shooter...

Yes, I think I can work with that. We can add a relief cut for the hammer if needed. The only downside would be that it may eliminate the ability to lower the hammer by hand on the longer scopes.

Thanks

Shadow mount

Well the only reason for me to mill the slide and direct mount the Deltapoint would be to co-witness irons or the ability to use irons if I have a dead battery on the RDS and not necessarily co-witnessing. It looks like it has room for a rear suppressor iron sight with the Deltapoint in front of it on the Tactical Sports slide. Otherwise if I want to retain the LPA dovetail, I could wait for your mount. Could it be designed to be as low profile as possible and set back to the rear. The comp hammer is already low and won't interfere with the adapter set further to the rear. Can you post a better photo of the hammer down with the mount you have?

Yes, that is how I would have to do it. $150 + shipping. I'll double check on Monday that the there is nothing in that slide setup that would change it from the Shadow.