E5MC Posted October 11, 2009 Share Posted October 11, 2009 I'm trying to set up my XL650 for 9MM. Per the manual I was threading a Lee U die in station 1. The die is to short to thread all the way to the shell plate. Am I doing something wrong? Link to comment Share on other sites More sharing options...
ChuckS Posted October 11, 2009 Share Posted October 11, 2009 I'm trying to set up my XL650 for 9MM. Per the manual I was threading a Lee U die in station 1. The die is to short to thread all the way to the shell plate. Am I doing something wrong? Try putting the lock nut on the underside of the tool head. Later, Chuck Link to comment Share on other sites More sharing options...
E5MC Posted October 11, 2009 Author Share Posted October 11, 2009 Thanks Chuck Link to comment Share on other sites More sharing options...
Rolex Posted October 11, 2009 Share Posted October 11, 2009 Just use one of the Dillon nuts from the other die, use as if its a Dillon die works like stock- because its thiner that the Udie nut! Link to comment Share on other sites More sharing options...
jasmap Posted October 11, 2009 Share Posted October 11, 2009 Just use one of the Dillon nuts from the other die,use as if its a Dillon die works like stock- because its thiner that the Udie nut! +1. This is what I did. The "U" die nut wouldn't allow me to lower the die far enough but the Dillon nut does. Link to comment Share on other sites More sharing options...
E5MC Posted October 11, 2009 Author Share Posted October 11, 2009 I took out the rubber O ring and turned the locking nut upside down and had enough thread that way. The locking nut is only threade about half way. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now