Friedrich_der_Grosse Posted July 23, 2022 Share Posted July 23, 2022 Greetings everyone! So I've recently mustered up the confidence to tinker with CZ pistols on my own, and though I've had success with disassembling everything without too much difficulty, the only thing that worries me is fitting a CGW T3 or even doing minor fitting with a T5 disconnector. My questions come down to me not really knowing what tools to use to remove material on the disconnector, so any advice on what tools I'm supposed to use for fitting are greatly appreciated! I'm a noob, so sorry about that. Link to comment Share on other sites More sharing options...
mveto Posted July 24, 2022 Share Posted July 24, 2022 I used a dremel with a fine diamond bit at the lowest rpm. It’s worked great on the couple discos I’ve fit Link to comment Share on other sites More sharing options...
jpm2953 Posted July 24, 2022 Share Posted July 24, 2022 I used a flat file and then some 600 grit paper to do the final smoothing Link to comment Share on other sites More sharing options...
rowdyb Posted July 25, 2022 Share Posted July 25, 2022 When I did it for a living we used an end mill to remove the required material. Then a wool felt polishing wheel and a jewelry polishing compound Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now