greatlakes08 Posted September 2, 2021 Share Posted September 2, 2021 I was looking at converting a pistol length PCC and making my own shroud and getting it pinned so I can run it as a rifle. Has anyone done this? Any suggestions on where to get materials? If someone knows where to buy one similar to what Taccom uses on their ULW barely I would definitely just buy one instead. It needs to have 9/16 -24 threads.... Link to comment
Steelin Posted September 3, 2021 Share Posted September 3, 2021 Buy a Taccom ULW it will change your life. Link to comment
greatlakes08 Posted September 3, 2021 Author Share Posted September 3, 2021 I already have one. I want to have a 10 inch barrel and six inch shroud. Link to comment
usmc1094 Posted September 4, 2021 Share Posted September 4, 2021 The shroud goes all the way back to the barrel extension. If you want to add something to the end of a 10inch barrel it would be more like a muzzle break. You could put a shroud over the entire 10inch, all the way back. Link to comment
greatlakes08 Posted September 4, 2021 Author Share Posted September 4, 2021 Muzzle brake would be okay with me. Do you know of one that’s 6 inches long on the market? Link to comment
R1valdez Posted September 4, 2021 Share Posted September 4, 2021 Brekke makes a 6 inch comp extension Link to comment
robertg5322 Posted September 5, 2021 Share Posted September 5, 2021 Had a squib issue that left four bullets and three bulges in the last six inches of a barrel, but did no damage to the first ten inches. Cut the barrel, and installed a .75" ID aluminum tube over the gas block area (it was a perfect fit). Pinned and welded it in place. It shoots great, balances nicely, and saved me the cost of replacing the barrel. All of that said, unless you have a barrel laying around, or one damaged toward the muzzle, it's not worth the money to buy a barrel and shorten it when you see what Taccom charges for their barrels, and the Taccom barrels are ramped, and work well. Taccom makes good stuff, and I have one of their 12/16 barrels on my Glock mag gun. The barrel I did was damaged, so it was cut, shroud, and use, or toss in trash. It has no ramp, so I use it on my Colt lower, and it works great. On Glock mag guns though, I'd suggest something with a ramp. Link to comment
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now