mitommy Posted April 30, 2020 Share Posted April 30, 2020 I have installed a Taccom 16” ULW Barrel and a 15” handguard. That leaves about 1” of barrel sticking out past the handguard. I plan to shoot some matched that will require PCC and shotgun. I’m concerned about how the end of the barrel will hold up when I have to dump the PCC to transition to the SG. I was thinking of adding something to the end of the barrel to take the beating. What i had in mind is a PVC cap, with the center cut out to the ID of the barrel. Is my concern to protect the (aluminum) end of the barrel valid, or do you think it will hold up ok? Does the end of that barrel get to hot for PVC? Does anybody have any other thoughts / ideas? Link to comment
gerritm Posted April 30, 2020 Share Posted April 30, 2020 Shot one for several years in USPSA & UML 3-gun dumping it many times. If you are talking about the pinned aluminum housing it will not be a problem. No damage after thousands of rounds and many matches. gerritm Link to comment
mitommy Posted April 30, 2020 Author Share Posted April 30, 2020 3 hours ago, gerritm said: Shot one for several years in USPSA & UML 3-gun dumping it many times. If you are talking about the pinned aluminum housing it will not be a problem. No damage after thousands of rounds and many matches. gerritm that’s exactly what i was concerned about. Thanks for the reassurance. Link to comment
gerritm Posted April 30, 2020 Share Posted April 30, 2020 I had even painted the tube and other than a few chips at the very end nothing. gerritm Link to comment
TRUBL Posted May 1, 2020 Share Posted May 1, 2020 Don't worry about it.......run it, run it like it owes you money!! Link to comment
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now