Cr Speed Mag Pouch Question

[boo radley]

I bought a couple of CR Speed Vera Mag Pouches.

One of the parts included in the baggie is a slim plastic piece about the side of a jumbo paper match. What on earth this for? The instructions don't reference it.

As an aside, does anyone else think ResComp writes some really poor documentation? Gear seems good, however.

[AWLAZS]

That fits between the holder and the belt to keep it in place.

[boo radley]

Thta fits between the holder and the belt to keep it in place.

<{POST_SNAPBACK}>

<checking....>

Oh.

Thanks!

[Cuz]

That fits between the holder and the belt to keep it in place.

<{POST_SNAPBACK}>

Can you provide a bit more explanation? I don't understand your response. I just got some of these pouches but was a bit too embarrased to ask the question.

Thanks,

Cuz

[AWLAZS]

That fits between the holder and the belt to keep it in place.

<{POST_SNAPBACK}>

Can you provide a bit more explanation? I don't understand your response. I just got some of these pouches but was a bit too embarrased to ask the question.

Thanks,

Cuz

<{POST_SNAPBACK}>

The small black wedge looking thins get place between the mag holder and the belt to keep the mag holder from twisting on the belt. I slid mine in at the top on the narrow side of the belt.

[9MX]

Thta fits between the holder and the belt to keep it in place.

<{POST_SNAPBACK}>

<checking....>

Oh.

Thanks!

<{POST_SNAPBACK}>

you may alsot opt to use velcro strips placed behind the the magpouch mount for a more secure fit.

[AWLAZS]

I used the velcro and some 12 guage wire. my pouches don't move at all even when my rig is off they don't slide around on the outer belt.

[boo radley]

Another question on these pouches: do y'all keep them above the belt hanger or below? Does it even matter? I figured it was better to swivel them so that the holder would be oriented above the belt, but I noticed the lettering on the hanger was now upside-down, and wondered if that wasn't "right."

[MoNsTeR]

I mount the pivot above the belt, though some others mount them below. Your preference.

[Loves2Shoot]

I mount the pivot above the belt, though some others mount them below.  Your preference.

<{POST_SNAPBACK}>

Ditto. I like the pouches higher also.

[Artack]

Thanks very much for this thread, as I to was ignorant to the belt holder/shim.

[Pro2AInPA]

An alternative to the shim is to drill and tap the bottom of the hanger and then use a set screw to keep the hanger secure on the belt.

[CMV]

An alternative to the shim is to drill and tap the bottom of the hanger and then use a set screw to keep the hanger secure on the belt.

+1