Pinka Posted June 26, 2015 Share Posted June 26, 2015 (edited) Had this problem a couple months ago, while doing some dry fire the trigger started to get slow to return, felt like it would hang about half way back. Hadn't cleaned it in a while so tore it apart and cleaned it good, shot a couple matches with no problems. Last night problem started again, cleaned again and no joy, swapped out trigger return spring still hanging. Any ideas where I should start?? Thanks Oh ya, 75 Shadow, short dust cover. Edited June 26, 2015 by Pinka Link to comment Share on other sites More sharing options...
vixty Posted June 26, 2015 Share Posted June 26, 2015 Mine was doing the same thing a week ago. I cleaned and oiled between the trigger bar and frame and the problem went away. Link to comment Share on other sites More sharing options...
bockerSV Posted June 26, 2015 Share Posted June 26, 2015 Yupp that's all it is. Gunk getting between the trigger bar and inside of the frame. Can either clean it out or just lube it and you'll get by for a while. Link to comment Share on other sites More sharing options...
Pinka Posted June 26, 2015 Author Share Posted June 26, 2015 Thanks guys, I must have done a better job cleaning it last time, going to give it a shot now. Link to comment Share on other sites More sharing options...
BeerBaron Posted June 26, 2015 Share Posted June 26, 2015 Get a can of brake cleaner. It'll blast out any crud around the trigger bar etc. Link to comment Share on other sites More sharing options...
asimonp79 Posted June 26, 2015 Share Posted June 26, 2015 Get a can of brake cleaner. It'll blast out any crud around the trigger bar etc. Actually any good cleaner with air pressure will do- but the brake cleaner is damn good choice Link to comment Share on other sites More sharing options...
vixty Posted June 26, 2015 Share Posted June 26, 2015 i need to find a better lube for mine. I use clp but with all the dry firing I do this issue always comes up more than it should. I thought about using slide glide.....Anyone ever try it? Link to comment Share on other sites More sharing options...
d_striker Posted June 26, 2015 Share Posted June 26, 2015 Check the mag release spring screw as well. Mine was doing that and sure enough, the screw was loose. Link to comment Share on other sites More sharing options...
Pinka Posted June 27, 2015 Author Share Posted June 27, 2015 Thanks again for the help guys little lube on both sides of the trigger bar took care of it until the next cleaning. Link to comment Share on other sites More sharing options...
Vanniek71 Posted June 27, 2015 Share Posted June 27, 2015 i need to find a better lube for mine. I use clp but with all the dry firing I do this issue always comes up more than it should. I thought about using slide glide.....Anyone ever try it? I use Slide glide on the slide rails of my CZ's and then Cudalube on the barrel. Guess I could use Slide Glide all over but I find the Cudalube comes off and takes the carbon with it which makes cleaning a breeze. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now