kevinj308 Posted September 4, 2015 Share Posted September 4, 2015 The midway sale was over, but Graf's still has the good price on Lapua 9mm. Got some on the way, if nobody else gets to it I'll post the groove dimension. Link to comment Share on other sites More sharing options...
Alaskan454 Posted September 5, 2015 Share Posted September 5, 2015 So has anyone switched to 9x21 brass yet? Link to comment Share on other sites More sharing options...
Gregg K Posted September 5, 2015 Share Posted September 5, 2015 The midway sale was over, but Graf's still has the good price on Lapua 9mm. Got some on the way, if nobody else gets to it I'll post the groove dimension. Thanks for the heads up on Grafs, they are cheaper than Starline with the sale and free shipping right now. Dave said the groove diameter on his samples ran .341 to .343 so just a tiny bit larger than Starline. Link to comment Share on other sites More sharing options...
kevinj308 Posted September 5, 2015 Share Posted September 5, 2015 Cool, thanks for the spec. Link to comment Share on other sites More sharing options...
kevinj308 Posted September 12, 2015 Share Posted September 12, 2015 Just got some of these http://www.wheelgun-supply.com/S_W9MM38SX8_EXTREME_STAINLESS_STEEL_MOON_CLIPS/p3073750_14537981.aspx They fit the Lapua 9mm brass beautifully!!!! The factory 0.035 clips had a little wobble and felt like they were pinching the case with just two points of contact if that makes sense. The case would kind of pivot between the two points of the cut out. The 0.040 wheelgun supply clips are snug but the case still spins freely in the clip, they just feel like a good fit for the Lapua. Kevin Link to comment Share on other sites More sharing options...
Forrest Halley Posted September 15, 2015 Share Posted September 15, 2015 I am running everything but Remington. I have sorted the brass into four categories: Federal, Winchester, Speer/Blazer, and stuff for the M&P. Once I get enough Federal brass, I may not keep the Winchester and blazer separate. Link to comment Share on other sites More sharing options...
BadShot Posted September 16, 2015 Share Posted September 16, 2015 Are there any problems using the Lapua 9mm brass with the factory .035 TK moonclips? I tried a few and got some light strikes. Skip Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now