twister

I’ve got Nills with the open back strap, I like them.

I live in n/w Indiana and would come to your match.

Is it true you can use a Glock guide rod and spring in my M&P?

Thanks for the information, I’ll look into these.

I'm new to the M&P pistol, and would like to know where to buy magazines and parts like recoil springs and guide rods? I know where to get the trigger and front sight. Thanks for your help, Dave.

Thanks for the replies, I'm new to idpa trying to figure out what I can do and stay within the rules.

Can I change anything and stay in the same class? And, thanks for the info.

I recently purchased a 5" 2.0 for IDPA and would like to know what class that would put me in? I'm new to IDPA and don't know the rules, so any help is appreciated, thanks, Dave.

Will I need to replace the front sight on my gun?

Thanks for the help yigal.

Can I put an adjustable rear sight from CZ Custom in the stock in the stock cut out on my TSO? Thanks for any help on this, Dave.

Tampa, which holster are you using? Thanks, Dave.

Toolguy, where can get in line for these new products as soon as they’re available? Thanks, Dave.

Thanks for the help.

Thanks John.

Thank you for the information.

I would like to know the twist rate on a Tactical sport 9mm barrel, I've checked around the internet and come up with nothing, any help on this is greatly appreciated, Dave.

I just ran across Matt's Bullets website, and wanted to know if anyone is using them? First off, they are pricey for a lead bullet, and I'd like some feed back on them before I spend the money. The bullet I'm interested in, is the 125gr. wad cutter, to be used in PPC matches. Any help is appreciated, Dave.

Tommy, would you know of anyone in the states who sells the H&M’s 125grain hollow base wadcutter? I would really like to give that bullet a try, thanks.

practical_man thanks for the information. I just miked some of my Hornady hollow base wadcutters and they measured in at .356, which seems small for 38 special bullet. I am working on some loads for a double ended wad cutter that is coated.

Rusty, thanks for tip, I’ll check it out.

First, thanks for all the helpful information. I buy all my Bullets lubed, I was going to wash all the factory lube off, then relube the Bullets myself. I’m using 3 different brands of hollowbase wadcutters. The leading I’m getting is in the cylinder and the beginning of the barrel, not so much at the end of the barrel. The Bullets are sized .358 and I’m using a couple different powders, Bullseye, and Winchester WST. I load a charge of 2.7 in both powders.

I want to lube some wad cutter bullets to hopefully cut down on leading, and would like to know what is the best method? I've never tried this before, I'm hoping it will solve my leading problem. Thanks for any help on this, Dave.

My local gun store, Blythe's sporting goods in Valparaio, In. has a Checkmate for $3100, and they might deal a little on that price.

Tony, just wanted to say that is the nicest Tactical Sport I've seen.