Pinkerton

I’d like to know too! Pinkerton OUT!

Am I reading correctly? no shot gun sling needed?

Just installed it!! It's great!! Thanks, Pinkerton OUT!

Just ordered a set!!!! Thank You!!! Pinkerton OUT!!!

I have Mepro Tritium "High" sights on my USP Tactical. They work great fwith my can. Pinkerton OUT!

I have the same problem. The only solution I have found is to set the die as high as possible and the internal seater aslow as possible but I still have to remove the cartridge from the press.... Pinkerton OUT!

Steve, I think you guys put on a great match!! Team Prozak will be there in all our "Glory!?!?" Pinkerton OUT!

I too would like to know about an optic for heavy metal/ he-man. Of course I'm still bitter .45 GAP was allowed but 10mm wasn't. I do think carrying the pistol through out the match is a good thing!! Less of a game and more "tactical" Pinkerton OUT!

It is a FA Uzi In .22, 9mm, 45 it is awesome. I'll try the stronger spring. Any ideas where to find one? Thanks for the help!!! Pinkerton OUT!

300lbgorilla The issue is it's an Open bolt with Advanced Primer Ignition so the bolt is never truelly closed. I think a stronger spring might make the bolt faster on closing so it would be "more closed" Thanks for the idea. The guy I bought this from told me that he has had none of these problems with the other kits he's sold to other guys.

Shred. No it's not a 40 Short and Weak barrel. Joe Law 99 The primers are center hit and the ones that are still in the cases show serious over pressure signes. Skywalker I think you're right I just figured that the open bolt would relieve that pressure. (on ther seperated cases the primer is still in the csae) That and I've run HOT 9mm through the 9mm set up with only a rate of fire increase. I'll give the crono a try.

Hi, I have a 10mm load that I have used in my Delta with no pressure signs. It's a relitively lite load. OK so here is the problem. I have a Open bolt UZI. It fires Federal red box but blows the primers out. Wierd because I seem to remember that Federal is a lite load. When I use my Reloads with new bress I get case seperations. Scary!! The same batch of my loads rounds in my Delta are fine. No pressure signs/ no case seperations infact they seem lite. The Federal I sent back to Federal and they said that they were fine and at about 1050 fps. (well within spec) The guy that did the bolt and barrel says that they are both in spec and run fine in his with UMC 10mm. I haven't been able to get UMC 10mm locally. What would cause these issues? Any help or guidence would be appreciated. Thank You, Pinkerton OUT!

Hi, I just wanted to thank Ivan. Today UPS dropped off a 1K 9mm brass from Armscor. I has Emailed Ivan about some problems I'd had previously with the brass. Thank You again I'll load this up and I'm sure the problems have been fixed. Pinkerton OUT!

I use a stool, a chair and standing. The stool when I'm reloading. The chair when I'm resizeing/ trimming And standing when sometimes durring both. Pinkerton OUT!