mciver52

I did a slight undercut up front on one of my Eagles and it works well with me. Basically just rounded off the sharp edge of the guard

Ya I know Yong, I work about 50 miles south of him. Knows his stuff.

Run that FSS and try leaving the original trigger return spring in...that has always given me the lightest trigger pull.

Looks good Darryl.

I was there for the 1st one, great time. Good luck this year

Just ordered a couple DPPs. Better keep this in mind, they are going on duty guns. That’s no bueno

My fellraisers are 2 years old and still have great tread. They don’t see much pavement or a ton of gravel though.

Might be worth hanging on to...pretty cool story behind it if it pans out.

Did you send them an email or call? Every time I've called I've been able to speak to a person and get my questions answered.... Just a thought.

Just ordered MBX mags...haven't heard too many issues so figured I'd give them a shot in my Eagle. Custom built gun, hard to complain about 350 bucks to try some mags.

I just recently switched over to an Eagle for ESP in 9mm. If you're going to go 1911/2011 it's a very hard gun to beat.

Just installed the semi drop in in my 5" gun on Friday and shot it yesterday at the range. Put 10 rounds through it...115 grain Winchester....and then sat down at 25 yards, set the gun on a bag and pushed out 5 rounds for this...... I didn't take a great deal of time but didn't rush it either. The gun is considerably more accurate and POA/POI did not change at all for me. Install was not quick! I have a cerekoted slide and it made things less than fun. Install time was about 3.5 hours but I did take plenty of time. Lock up is TIGHT. I ran 115, 124, 147 and hand loads and had zero issues while running a 14# recoil spring. So, shots 11-15 out of the barrel from a sand bag with moderate concentration yielded a sub 2" group at 25 yards....for what that's worth.

Thx

Stock STI

Dawson kit it is. Any benefit to 140mm springs in 126mm tubes? Better upward pressure on the follower?

Custom built 2011 gun with primarily STI parts... When the mag does lock the slide to the rear on an empty chamber the slide lock lever is barely in the notch. Seems like maybe the guts of the magazine (spring) are not strong enough to fully force the slide lock lever up? Is this something that a Grams spring and follower will usually fix. I'm just running 126mm mags and primarily only run IDPA round count (10). If I push on the bottom of the mag when I push the slide to the rear it locks up fine...leading me to the spring weight question. Thanks in advance.

Grizz Precision built 2011 in 9mm. KKM precision barrel and other goodies.