Jump to content
Brian Enos's Forums... Maku mozo!

Shrek1

Members
  • Content Count

    49
  • Joined

  • Last visited

About Shrek1

  • Rank
    Looks for Match

Profile Information

  • Real Name
    Shane C Smith

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Shrek1

    LH shooter - gen 5 Glock? Anyone?

    Just picked up my gen 5 g34, enjoying it greatly. Especially since the g34 gets the extended slide release. I started practicing my reloads, very happy with the outcome so far and easy of use. Sent from my iPhone using Tapatalk
  2. Will the plus three work for uspsa production as well? Sent from my iPhone using Tapatalk
  3. Shrek1

    Hoster for gen4 g34

    I love bladetech! Also ghost has a good one. Currently i have been running a Red Hill Tactical Holster. Extremely strudy, double layer kydex. Sent from my iPhone using Tapatalk
  4. Shrek1

    New Production Rules

    Any ideas if this will work on a gen5? Sent from my iPhone using Tapatalk
  5. Shrek1

    Mods for g34 gen5

    What mods are working well for g34 gen5 for production? Just purchased a g34 gen5. Love it! Already ordered 3.5 connector, extended mag release and ghost base plates Sent from my iPhone using Tapatalk
  6. Any recommendations for good base plates for uspsa production g34 gen 5? thanks
  7. Shrek1

    CZ Shadow 2 mods for Limited

    Currently I have my Shadow 2 setup ideally for production and want to start considering options for limited. Already have a magwell, going to order lokgrips to fit with the magwell, extended safety and SA trigger from Cajun gun works. What else?
  8. Shrek1

    Primer or firing pin issue CZ Shadow 2?

    That was the issue I was having. Thank you for the information
  9. Shrek1

    Primer or firing pin issue CZ Shadow 2?

    Thanks, fixed the issue, primers weren't getting seated properly and using Winchester primers as well.
  10. Shrek1

    Primer or firing pin issue CZ Shadow 2?

    Surprisingly they are seated to low is what i have found
  11. So I reload using CCI 500 primers with approx 3.3gn titegroup and 135 gn bluebullets. Using an extended firingpin with a reduced firing pin spring and 11 lbs hammer spring. Had no issues until yesterday and again today. The bullets were not firing and there was an indent in the primer, but all would fire after multiple (2-3) DA strikes. Possible issues - need heavier hammer spring, primers are bad. Any thoughts or recommendations to fix this issue would be appreciatted. Thanks
  12. Shrek1

    Shadow 2 and ultrasonic cleaning

    Does it work well? If so what works? I am skeptically. thanks
  13. I recently setup a lee loadmaster for reloading 9mm, the auto powder disk will not go smaller the 3.0 cc which is giving me approx.3.6 - 4 gn of powder. Has anyone else had this issue, what solutions? I ordered the lee auto-drum and the adjustable disk as possible solutions. Thanks
  14. So the screws i used 5-40 striped, any recommendations for good screws that wont strip?
  15. Shrek1

    Delta point pro issues

    Thanks for all the thoughts.
×