NOT QUITE RIGHT

The MagLula puts the bullets in the mag, not the mag in the gun... With that being said maybe he should carry a small hammer with a rubber end so as not to damage the mag. I told everyone up front that I was NOT QUITE RIGHT. Sorry I should have read better.

Can we send these guns back to SIG for the fix? But is the failure to feed start with a extraction problem?

My problems started after several 1000 rounds and I do not have a clue what is wrong. I tried the hotter loads and different COL's without any better results.

Please let us know if this extractor fix works. I just started to jam and 1000's of rounds without a problem. And I have looked at everything.

Get a MagLula

Where can I buy parts for my 41 other than S & W ?

Powder Valley or Mid South

They are no good. Drop and trickle

Check snipershide forum but I would not use the stuff. By the time you add the water lemi shine and the media you only have less than 2lbs left for brass in a 15lb tumbler and you can't go to bed while it is cleaning

Get the Redding GRX

Throw a little Redding Imperial on every 10th case or so

Berrys

Try IMR 7625

Use a good taper crimp die for the 38 and a roll crimp for the 357mag

Does anyone have a good 148 DEWC Load that is very clean for a revolver?