full length resizing your own brass

[lynn jones]

never mind!

Edited May 8, 2008 by lynn jones

[BritinUSA]

There's an article about this in the latest Front Sight. In the Reloading section.

[kevin c]

There's an article about this in the latest Front Sight....

Which I still haven't received...

[kevin c]

I got my FS.

The 40 Gizmo is pretty much the same as what the good Dr. Dunn so kindly sent me: a custom 40 die with a push through rod, similar to a bullet sizing set up. John's version was put out by a fellow who no longer makes them.

It works pretty well.

Kevin

[RePete]

I got my FS.

The 40 Gizmo is pretty much the same as what the good Dr. Dunn so kindly sent me: a custom 40 die with a push through rod, similar to a bullet sizing set up. John's version was put out by a fellow who no longer makes them.

It works pretty well.

Kevin

Any chance of getting a scanned copy of the article? Thanks.

[buddy_fuentes]

I'm not saying my way is better, just simpler for me. I use a Lyman "C" press and an EGW die in forty. I run any "new" brass that comes into my house through this set-up. I then have a sized and de-primed case with no bulge. I have regular Dillon dies in my 650.

I had the EGW die in the 650 for a while, but had some issues with it staying set (short) and the incoming case not aligning up properly each time.

After the case is run through my STI, I run it through the press as I normally would.

[Stefano]

Me too I've seen the FS article about the 40 gizmo .....

Does anybody knows the e-mail address and/or the website link of the producer ?

I would like to ask if they have also a 9mm. version.

At the moment I haven't near my my FS copy ....

Thanks

Edited May 24, 2008 by Stefano