lynn jones Posted May 8, 2008 Share Posted May 8, 2008 (edited) never mind! Edited May 8, 2008 by lynn jones Link to comment Share on other sites More sharing options...
BritinUSA Posted May 8, 2008 Share Posted May 8, 2008 There's an article about this in the latest Front Sight. In the Reloading section. Link to comment Share on other sites More sharing options...
kevin c Posted May 10, 2008 Author Share Posted May 10, 2008 There's an article about this in the latest Front Sight.... Which I still haven't received... Link to comment Share on other sites More sharing options...
kevin c Posted May 14, 2008 Author Share Posted May 14, 2008 I got my FS. The 40 Gizmo is pretty much the same as what the good Dr. Dunn so kindly sent me: a custom 40 die with a push through rod, similar to a bullet sizing set up. John's version was put out by a fellow who no longer makes them. It works pretty well. Kevin Link to comment Share on other sites More sharing options...
RePete Posted May 14, 2008 Share Posted May 14, 2008 I got my FS. The 40 Gizmo is pretty much the same as what the good Dr. Dunn so kindly sent me: a custom 40 die with a push through rod, similar to a bullet sizing set up. John's version was put out by a fellow who no longer makes them. It works pretty well. Kevin Any chance of getting a scanned copy of the article? Thanks. Link to comment Share on other sites More sharing options...
buddy_fuentes Posted May 14, 2008 Share Posted May 14, 2008 I'm not saying my way is better, just simpler for me. I use a Lyman "C" press and an EGW die in forty. I run any "new" brass that comes into my house through this set-up. I then have a sized and de-primed case with no bulge. I have regular Dillon dies in my 650. I had the EGW die in the 650 for a while, but had some issues with it staying set (short) and the incoming case not aligning up properly each time. After the case is run through my STI, I run it through the press as I normally would. Link to comment Share on other sites More sharing options...
Stefano Posted May 24, 2008 Share Posted May 24, 2008 (edited) Me too I've seen the FS article about the 40 gizmo ..... Does anybody knows the e-mail address and/or the website link of the producer ? I would like to ask if they have also a 9mm. version. At the moment I haven't near my my FS copy .... Thanks Edited May 24, 2008 by Stefano Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now