Nimitz Posted February 10 Share Posted February 10 I'm trying to get my reloading back up and running and I'm having a problem with the cases not being centered on station 2 and therefore on the up stroke I can't seat the primer. It looks like the rotation plate does not center the case correctly over the primer so that will get inserted straight what should I be looking at to adjust to fix this? thx! Link to comment Share on other sites More sharing options...
HesedTech Posted February 10 Share Posted February 10 46 minutes ago, Nimitz said: what should I be looking at to adjust to fix this? thx! Did you read this thread? Dillon also sells an alignment tool. Link to comment Share on other sites More sharing options...
bravobravo Posted February 11 Share Posted February 11 (edited) Ken, this is what worked for me, as per Dillon "Your alignment issue is probably going to be fixed by adjusting the indexer block #16776 (p 48 in manual). The two bolt holes are slotted. Pushing this block towards the rear of the bench advances the shellplate further clockwise, pull it towards the edge of your bench to retard advancement." The alignment tool Dillon sent me basically showed how far and in what direction to adjust the indexer block. Most likely by trial error you can make the adjustment without the tool. BTW, plus 1 for your Steel Challenge dry fire banners. After the gun and timer it has been the most important training tool I have used. Edited February 11 by bravobravo Link to comment Share on other sites More sharing options...
Nimitz Posted February 11 Author Share Posted February 11 Cliff - thx! I'll pull out the manual & see if I can get it lined up Appreciate the kind words on the banners! It was/is the single most important training tool to enable the success' I achieved ... HesedTech - I;ll check out that tread as well, thx! Link to comment Share on other sites More sharing options...
dillon Posted February 12 Share Posted February 12 Product Videos | XL650 (dillonprecision.com) Link to comment Share on other sites More sharing options...
Nimitz Posted February 12 Author Share Posted February 12 looks like that was the issue ... thx all! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now