how to increase holster spacing away from belt

[davsco]

with the sideways c-more and extended racker, the belt is interfering with the racker.  i had to raise the gun up to where the racker is above the belt but it sits too high for a comfortable draw.  double alpha race master magnetic.  on another gun, the slide racker is ambi so i just run it on the right side, not an option with this gun, at least without some machining and a different slide racker.

 

perhaps some sort of spacer at the belt attachment point?

some sort of spacer where the 'drop' part of the holster attaches to the belt?

find or make a longer piece (rod) that goes from the bottom of the drop part to the actual holster?  worried there might be too much torque on that part if i make it too long.

someone makes a better/wider drop offset piece?

something else?

 

thanks!

[rishii]

I did that years ago to a cr speed holster

i went to my local Ace hardware and bought nylon spacers and longer screws

 

[davsco]

so as it turns out, the rod that sticks out from the drop piece is long enough to slide out the block a little and still have the screws bite, so i did that and grinded down the slide racker a little.  should give me just enough clearance to holster and draw without issues.

[Robertwil18]

Everglades MRH 

 

[Silverscooby27]

I don’t know if it would work with the race master or not because I’m not familiar with that model, but for the Alpha X there is an extended ball joint that will bring the gun out a little farther.

 

https://www.doublealpha.biz/us/alpha-x-extended-ball-joint-rod