xjwalt666 Posted March 25, 2023 Share Posted March 25, 2023 What is everyones take on repeatability with seat/crimp dies? I just picked up a super 1050 and want to be able to run a bullet feeder and powder check and will need to go to a seat/crimp die. I've seen people that love them and that hate them. Is there one that is better than others? Or should i just keep an eye on the powder level in the cases while loading and keep the dies separate? Link to comment Share on other sites More sharing options...
4n2t0 Posted March 29, 2023 Share Posted March 29, 2023 (edited) If you set them up properly they'll do exactly what you need them to do. Here's a sample of the discussion that will probably ensue... Edited March 29, 2023 by 4n2t0 Link to comment Share on other sites More sharing options...
pmspaul Posted March 29, 2023 Share Posted March 29, 2023 I've had no issues with running a seat/crimp die for my 9mm reloading. I spot check cartridges and on average they're +/- 0.004 max, which is good enough for me for 9mm. I try to visually check each case before the bullet feeder station, but I use a DAA powder check as my primary powder check. Link to comment Share on other sites More sharing options...
Zachjet Posted March 29, 2023 Share Posted March 29, 2023 I seat and crimp. Haven’t had a problem Link to comment Share on other sites More sharing options...
HesedTech Posted March 29, 2023 Share Posted March 29, 2023 On 3/25/2023 at 11:13 AM, xjwalt666 said: I just picked up a super 1050 and want to be able to run a bullet feeder and powder check and will need to go to a seat/crimp die. Personally have never ran a powder check die and have lost count of how many rounds, maybe approaching to 100K now, without it. But if it makes you feel more comfortable the combined die works fine, except a bit tricky with coated bullets. Why? Because it starts to close the bell down before the bullet is fully seated and can scrape the coating off. I have used the combined die on a 550 so I could use a bullet feeder in a station. Found it works best with plated or FMJ bullets. Link to comment Share on other sites More sharing options...
xjwalt666 Posted March 31, 2023 Author Share Posted March 31, 2023 Thanks all, I have never run a powder check before either so I'm not really sure why it concerns me now. I'm only going to be loading major pf ammo on this press so obviously the cases will be pretty full that I should be able to tell by eye if its close at least. I just see a lot of people use the powder check and was curious how the seat/crimp dies do for consistency. Link to comment Share on other sites More sharing options...
bravofox Posted April 12, 2023 Share Posted April 12, 2023 I seat and crimp on one position as well. it took a little while to get it just right, but now it's working pretty well. I case gauge each round, and the couple I come across that dont pass, I run through a factory crimp die and they're good to go. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now