Two loaders and one bullet feeder

[22h2]

Does anyone run two loaders with one bullet feeder?  if so can you post some pics?  I would like to use one bullet feeder with my 550 and 750 loaders.  

 

Thanks 

[tmz]

I have done it but then I switched things around and ran one case feeder with two bullet feeder’s. 
 

 

[22h2]

did you have issues with the bullet feeder running two machines?

 

[tmz]

No not really they seem to work fine it just seemed  to be so cluttered there wasn’t  an easy way to set things up so it was nice and clean.

[22h2]

Yeah I can see that, they offer a extension I hope to be able to add some distance between the two, I hope someone can post some pics that have already figured it out lol 

[George16]

Here’s a picture of my MBF between the RL1100 and 650. I bought the extension from DAA and cut it to length. 

 

[m700]

if you have it set up to hang on case feeder just move it back and forth. I haven't seen the need for having it on its own post. I have noticed that after 500 rds or so it starts working its way around and holds side tension on the bullet feeder die and will cause it to not close after bullet comes through and dump. For a while i just slid it forward every 300 rds or so but ended up taping a piece of cardboard to case feeder to prevent it from working its way back.

[22h2]

George16 any issues with it feeding both machines? That’s a slick set up, I would be looking at duplicating something similar. 
m700, the 750 has a case feeder but the 550 doesn’t, so I will need a mounting fixture of some kind, 

thanks for the replies. 

[George16]

4 hours ago, 22h2 said:

George16 any issues with it feeding both machines? That’s a slick set up, I would be looking at duplicating something similar. 
m700, the 750 has a case feeder but the 550 doesn’t, so I will need a mounting fixture of some kind, 

thanks for the replies. 

None so far. I use the 1100 for .223 and the 650 for 9mm.

[22h2]

Good deal thanks for the reply