Help, shadow 2 comp hammer and short reset dis-connector fitting

[Magictalent]

Hi

I just installed the CZ comp hammer and short reset dis-connector.

Trigger do not feel right.

Feel like the after the sear release the hammer, trigger bar still catch on the disconnector.

 

Any one have this experience? How to fix?
Thank you very much in advance. 

 

 

[WhiteDingo]

It appears that your SA let off and DA let off are in almost identical spots. I would recommend adjusting the disconnector to allow for DA let off slightly sooner. The underside of the wing on the disconnector needs to be massaged slightly for an earlier let off.

 

Not an uncommon adjustment when installing that hammer and a short reset disconnector. I've seen it less often with the CGW hammers, but sometimes there as well.

Edited December 2, 2019 by WhiteDingo
More info

[Magictalent]

2 hours ago, WhiteDingo said:

It appears that your SA let off and DA let off are in almost identical spots. I would recommend adjusting the disconnector to allow for DA let off slightly sooner. The underside of the wing on the disconnector needs to be massaged slightly for an earlier let off.

 

Not an uncommon adjustment when installing that hammer and a short reset disconnector. I've seen it less often with the CGW hammers, but sometimes there as well.

Take off material under both wings right? Thank you.

[WhiteDingo]

Correct. It probably won't take much.

[NCShadow2]

Call Cajun.  They will help regardless

[marcool]

I have the same issue.  Is it "C" area I am supposed to polish?  Thanks.