Palmetto pcc bullet setback

[dtuns]

I was loading some dummy rounds and doing plunk test and got this even with factory ammo. I have not shot the gun yet it’s new from palmetto. It’s setting bullet back in to case ast well.

 

 

Sent from my iPhone using Tapatalk Pro

[dtuns]

The bullet hits feed ramp not sure if this needs to be rounded a little with dremel or something.


Sent from my iPhone using Tapatalk Pro

[Flatland Shooter]

Consider contacting Palmetto.  I've only contacted their customer service once and they busted their butts to get things right.

 

 

[AdamM]

My Palmetto 9mm does not have a feed ramp and will ding the bullet slightly, but not as bad as yours. I wonder if your mags are too low so it's causing a realty hard angle hit?

[robertg5322]

Taccom feed ramp fixed this issue on my ATI (NFA clone) AR9. Only works on Glock mag guns though.

[sniemann]

This happened on mine as well, but only with a full 40+ round magazine.  Smaller magazines, and downloaded 40+ round magazines, worked fine.  Installed Taccom feed ramp and all magazines work fine.

[dbgeek]

This happened to mine.  Almost exactly.  There is a feed ramp on the lower part of the chamber, but they left the sharp edge at the entrance to the chamber.  I put a nice radius on it and then polished that area.  Runs like a champ now.

[dtuns]

18 hours ago, dbgeek said:

This happened to mine.  Almost exactly.  There is a feed ramp on the lower part of the chamber, but they left the sharp edge at the entrance to the chamber.  I put a nice radius on it and then polished that area.  Runs like a champ now.

Same with mine and rounded and polished got a little better but it seams to also be a magazine problem with ETS mags I bought a factory glock mag and no issues.

 

[dtuns]

Well thought different mags worked. I still have no word from PSA.