dtuns

If Hogrider doesn't take it I will.

Yes the big main bearings. The shim goes under shell plate between press and bearing of shell plate. You can get the shims at Mcmaster Carr P/N's 98089A513, 98055A513 and the main bearings were these KOYO JAPAN 6910 2RS Deep Groove Ball Bearings 50x72x12mm 6910RS 61910-RS takes two of them

I had an LNL and also took me awhile to get running but was running well. I went to x-10 cause of swaging and extra stations so I can run powder check with bullet feeder. Didn't take me too long to get running well. I did shim shell plate up .008 at 20,000 rounds main bearings started making noise and my COAL went from +-.005 to +-.010. The bearing journals are a little big and bearings start to move. I replaced bearings with Koyo bearing and used green loctite and press is a lot smoother and my COAL is +-.005 or better. I've had problems with priming station but mostly from forgetting to put primer rod back in jams happen when you run it out of primers. The only issue I have now is the occasional station 1 brass not going in to shell plate but that's less than 1% of the time. I'm happy with the press and would do it again. I have not used powder drop I had a the Hornady already set so been using that so can't speak to any issues with powder drop. An I have a Mr bullet feeder that was on my LNL.

Did you call or email? Even on there facebook lives they say to call don't email.

I had same issue with factory hold down then switched to FW arms dynamic hold downs they are spring loaded so case variation isn't a problem anymore for me.

I use FW arms dynamic hold downs in swage and primer station. When I had expander in priming station I had a big variation in primer depths and swaging after I put hold down in both stations no longer an issue for me.

are you using hold down dies in swage and priming station?

At about 5 minutes talks about trimming your spring.

Hunters HD gold are awesome and now they make a red lens that makes the dot even better. I've only used gold lenses as I live in Oregon and overcast most of the year the golds will get darker when suns out.

I run RMR 124 HP with 3.8 of titegroup close to 140 PF

On My prodigy EGW ignition parts dropped in but had to refit the stock thumb safety.

Last weekends match 58 shooters not one production shooter and this coming weekend 82 signed up no production shooters. Level 2 Sectional match coming up in July has 167 shooters and 4 production shooters.

I put in the EGW kit and the tuned sear spring following this video and I have a nice 2# trigger.

I put an EGW fire control kit in my prodigy had to refit the stock thumb safety also had to fit Atlas trigger shoe and bow.

That picture is from the rule book.

Even with .40 and .45 die can only go down to shell plate.

What grip is on your prodigy and did you have to do any fitting?

If you Shoot IDPA bolt locking back is beneficial as they make you download magazines often and have reloads on the clock.

I've made a few purchases no issues.

Shootsteel are nice. I have 3 mini poppers.

Unless you can't find the Titanium in stock? Thanks for the info.

The holes in post below the case feeder are for bullet feeder that's why its so tall. If you cut it down won't be able to mount FA bullet feeder.

Has this ben replaced with the Redding NxGen Carbide Sizing Die?