SP01 Tac with S2 Mag Release

[rougeqc21]

Hey folks,

 

Replaced the mag release on my SP01 Tac this evening with a Shadow2 mag release from CZ. It feels like the mags are rubbing on the release, or right near that area and some drop free and some don't. If I mic the tubes there are some width variations and it is the wider of the mags that stick. But, I also noticed that some of the material from the release portrudes over the rest of the inside of the frame, specifically below the release on the front inside facing portion of the well. Any of you had to polish this down to sit flush?

 

Also have an S2 and the part definitely sits under the frame in that pistol.

[rougeqc21]

Called CZ and they said the part has to be fit most likely. Removed 3 thou of material and then polished it and the issue is resolved! Just wanted to update everyone.

[eerw]

Thanks. I installed one into a 75 Shadow lower with no fitting needed. So probably just a tolerance from the casting mode.

[Dutycalls75]

12 hours ago, eerw said:

Thanks. I installed one into a 75 Shadow lower with no fitting needed. So probably just a tolerance from the casting mode.

 

I did the same thing in a Shadow 1 loser and have had no problems.

[MoRivera]

I have one on my longslide (TS slide with SP01 frame), and it was drop-in.