PatriotDefense Posted November 7, 2015 Share Posted November 7, 2015 Not sure if we've been lucky on the last 6 guns we've done with the Xtreme sears but they required no fitting on the safety leg. Only thing they needed was polishing and smoothing out some main contact areas. Just wanted to give you guys a heads up and see if anyone else has had the same success when using the one piece xtreme sear. Link to comment Share on other sites More sharing options...
johnbu Posted November 7, 2015 Share Posted November 7, 2015 Factory hammer? That wouldn't surprise, but if a titan or delta.... Link to comment Share on other sites More sharing options...
eboadway Posted November 7, 2015 Share Posted November 7, 2015 Delta required a small bit of fitting, but not much. Link to comment Share on other sites More sharing options...
johnbu Posted November 7, 2015 Share Posted November 7, 2015 Did 3 stock 2's in thale past month and all needed safety leg fitted (xtreme sear/titan). Link to comment Share on other sites More sharing options...
BeckA11416 Posted November 18, 2015 Share Posted November 18, 2015 I have an unmodified stock 2, which extreme parts are must have? Does the extreme interrupter shorten the pre travel like on a cz? Link to comment Share on other sites More sharing options...
johnbu Posted November 18, 2015 Share Posted November 18, 2015 I have an unmodified stock 2, which extreme parts are must have? Does the extreme interrupter shorten the pre travel like on a cz? Current production s2 already have the xtreme interruptor. Link to comment Share on other sites More sharing options...
Justinmac13 Posted November 19, 2015 Share Posted November 19, 2015 I have an unmodified stock 2, which extreme parts are must have? Does the extreme interrupter shorten the pre travel like on a cz? The CZ CGW T3 disco is what some have recommended on here, I did this mod and it is much better than stock. I have to admit I had a moment of dumbassness when I was fitting mine though so it is not as good as it should have been but still much better than stock. I was first fitting the DA pull and had the sear cage in with the sear out so I could see what was going on. Once I got the DA fit I started removing material from the leg of the disco and forgot to put the sear back in. I have about 1/8th in of pretravel now in SA. Link to comment Share on other sites More sharing options...
waktasz Posted November 19, 2015 Share Posted November 19, 2015 (edited) One quick pass with the dremel got my xtreme sear to work with my Delta hammer. It also raised the trigger pull about 10 ounces compared to the stock sear in my Witness Classic 2....which was good because it was 28oz before that I had an issue with the xtreme disco. The hammer would slip off too early and fall to half cock about 1 in 20 times. I think it's because of the amount of side to side play the trigger and trigger bar in this gun had, but I had to go back to the stock one to resolve it. Edited November 19, 2015 by waktasz Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now