GregInAtl Posted April 22, 2015 Share Posted April 22, 2015 I have a 550b and the operating rod keeps creeping to the right out of the hole in the bracket. This causes the rod to slip out of the groove in the Primer Slide Roller and hence the primer slide is not feeding primers. Any suggestions on how I can prevent the operating rod from slipping out of the hole in the bracket Link to comment Share on other sites More sharing options...
outerlimits Posted April 22, 2015 Share Posted April 22, 2015 Just peen the end and shove it back in (geez, that sounds bad) Link to comment Share on other sites More sharing options...
benos Posted April 22, 2015 Share Posted April 22, 2015 From my notes: • Angle of Primer Slide Operating Rod (13869) - Release rod from rollers and swivel it 180º so it's pointing straight up - it should be parallel with the Primer Housing Sheild, or maybe outward "just a little"; it should not be "inward" at all. Link to comment Share on other sites More sharing options...
Mikethor Posted April 23, 2015 Share Posted April 23, 2015 Used to have the same problem until I put a rubber band over top of op rod and bracket, problem fixed. Link to comment Share on other sites More sharing options...
ejkoechling Posted April 26, 2015 Share Posted April 26, 2015 try a little grease in the hole. worked for me Link to comment Share on other sites More sharing options...
Dr Mitch Posted May 3, 2015 Share Posted May 3, 2015 I did the rubber band trick too. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now