shtr3 Posted January 12, 2015 Share Posted January 12, 2015 I just acquired a used 650 in good shape. This is my first time to set up 650 for 9mm. I'm using 9mm/38 conversion with green tube and small green insert on swing arm with the small silver insert underneath swing arm. When I am pulling handle where it gets to the top that should be the point where the next 9mm case is fed down into the slide, the case is dropping out halfway up on the stroke. Any advise? Sorry for using wrong terminology on any parts if I did so. Thanks in advance. Link to comment Share on other sites More sharing options...
dirtdarte Posted January 12, 2015 Share Posted January 12, 2015 Check your case insert slide... it can be configured two ways... the long ramp for pistol calibers and the short side for rife or longer case calibers. That will fix your problem. Link to comment Share on other sites More sharing options...
BritinUSA Posted January 12, 2015 Share Posted January 12, 2015 sounds like this issue : CLICK Link to comment Share on other sites More sharing options...
shtr3 Posted January 12, 2015 Author Share Posted January 12, 2015 thanks guys Link to comment Share on other sites More sharing options...
Kaskillo Posted January 12, 2015 Share Posted January 12, 2015 (edited) Check the case insert slide Part # 97082 Make sure it is setup for pistol (the short side) facing towards the shell holder. Edited January 12, 2015 by Kaskillo Link to comment Share on other sites More sharing options...
bayougump Posted January 12, 2015 Share Posted January 12, 2015 Where did you find a used 650 and how much was it? Being able to set one up for large and small primers is probably ideal for people who shoot both. Link to comment Share on other sites More sharing options...
GR8GIFT Posted January 19, 2015 Share Posted January 19, 2015 That's why I have 2 650/s one for small primers one for large primers. Also have a 550 for small lots of rifle ammo. Link to comment Share on other sites More sharing options...
AJE Posted January 20, 2015 Share Posted January 20, 2015 I figure the $80 for the extra primer assembly is a better value for me than a whole press. Two bolts and about a minute to change it out. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now