JFlowers Posted February 23, 2014 Share Posted February 23, 2014 Does anyone have a video or link to a video showing someone doing a weak hand reload with Tecloader tubes? Link to comment Share on other sites More sharing options...
outerlimits Posted February 23, 2014 Share Posted February 23, 2014 Link to comment Share on other sites More sharing options...
JFlowers Posted February 23, 2014 Author Share Posted February 23, 2014 Thanks! Not the best angle until that last reload, but that's what I wanted to see. Link to comment Share on other sites More sharing options...
Jesse Tischauser Posted February 25, 2014 Share Posted February 25, 2014 (edited) Just tilt the gun a bit to open the loading port to your weak side and let it rip. I try to get the forks in the chute then focus on getting the Tek loader back against the chute and push. Edited February 25, 2014 by Jesse Tischauser Link to comment Share on other sites More sharing options...
Neil E. Posted February 25, 2014 Share Posted February 25, 2014 I am not sure if it is the same for all shotguns but I had a tough time loading my SX3. I assumed the Tecloader tube needed to lay flat against the speed ramp. Doing it this way I was able to load 4 shell every 5 or 6 attempts. One or two shell would get out of line and would not feed. The I realised when I layed the tube on the ramp the angle was to shallow. The shells would kick up and jam. Now I concentrate on getting the forks against the ramp stops square. I keep the tube up off the ramp and push with one even quick motion. I load all four 98% of the time and faster than before not having to think about getting the tube flat to the ramp. A friend had the same problem with his SLP. Loading my way corrected it. This may be a Winchester or SLP issue and not any other shotgun. I hope this helped. Link to comment Share on other sites More sharing options...
mike_pinto Posted March 13, 2014 Share Posted March 13, 2014 Neil, not to hijack the thread but does your SX3 use the SLP speed chute? Link to comment Share on other sites More sharing options...
ziebart Posted March 23, 2014 Share Posted March 23, 2014 I just put the SLP chute on my SX3. It required minor filing of one set of pin holes to fit. Link to comment Share on other sites More sharing options...
mike_pinto Posted April 4, 2014 Share Posted April 4, 2014 Excellent. Thanks!! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now