Need a 38 load

[twister]

New to ICORE,need a load for 38 sp. Any help is appreciated,Dave.

[Punkin Chunker]

Try this:

handloads.com

Or the search function in the upper right of this page.

Edited April 14, 2012 by Punkin Chunker

[mwx40x40]

New to ICORE,need a load for 38 sp. Any help is appreciated,Dave.

158 LRN with 3.2 gr of CLAYS. Clean and soft. In some guns it may be too soft (sub minor). But, still a good load.

[inkedshooter]

158rn Bear Creek, 3.3-3.4gn Titegroup, Fed brass, Fed primer. Before switching to .38lc, this is the load I used for my 686 plus.

[sargenv]

38 spl brass

158 gr Bear creek Moly LRN

Federal SP primers

Solo 1000

4.2 gr will make minor in a 6" gun

4.6 gr will make minor in a 4" gun

[Pete Whyte]

How about a load for accuracy with the .38 special using 160 gr. Bayou bullets out to the 50 yard shots with a 627vcomp. Thanks

[kframe_mike]

How about a load for accuracy with the .38 special using 160 gr. Bayou bullets out to the 50 yard shots with a 627vcomp. Thanks

Throw about 3.7grs of WST under those bullets and call it good.I ended up sending a few of my LRN/WST loads out with a local shooter to IRC because they grouped so well at 50.-Mike

[JRB]

Hi Guys

I use 5.1 of WST in 38spl brass with a Zero 125 hollow point, or a 125 XTP hollow point.

Power factor is 128, makes it for Action Pistol and IPSC. ( minor power factor )

The 2 guns are a 681-c and a 686 preformance centre both with 6" barrels.

The load is flat shooting and at 50yrds the rounds go through the same hole if im lucky.

Forgot to add, Federal Small Pistol Primers, my Revolvers will not set off the others, to hard.

Hope this helps.

Russell

Edited July 17, 2012 by JRB