noylj Posted September 13, 2011 Share Posted September 13, 2011 Does any one make a bullet feeder, besides Lee, that feeds a bullet to be case at the seating station? I hate to lose the RCBS Lock-Out die and I am not going to seat and crimp at the same time. Thanks. Link to comment Share on other sites More sharing options...
jmorris Posted September 13, 2011 Share Posted September 13, 2011 The GSI feeds and seats on station 4. Here is one of mine with a homemade collator. Link to comment Share on other sites More sharing options...
Youngeyes Posted September 13, 2011 Share Posted September 13, 2011 The GSI feeds and seats on station 4. Here is one of mine with a homemade collator. Wow. Do you make housecalls? I want one of those. Link to comment Share on other sites More sharing options...
euxx Posted September 13, 2011 Share Posted September 13, 2011 Mr.Bulletfeeder uses standard Dillon 650 toolhead and sits on 3rd station after powder die (basically instead of the powder check). With DL550 the only option is to put it on 3rd station instead of sitting die and use sitting/crimping die on 4th station. Link to comment Share on other sites More sharing options...
Foxbat Posted September 14, 2011 Share Posted September 14, 2011 I hate to lose the RCBS Lock-Out die Just curious - has it EVER stop you from making a mistake? Link to comment Share on other sites More sharing options...
noylj Posted September 15, 2011 Author Share Posted September 15, 2011 In my case, it would be on a 1050. I have not had it find a bad charge. It is, however, very sensitive and will find the charges about 0.2gn over/under. I really think that they are too sensitive. However, I know that the charge is correct if there is no stoppage. So far, my only problems are with load development with out the Lock-Out die. I would use the Lock-Out die even then, but I can't find a powder funnel that fits the top of the Lee PTE die. All the funnels hit the primer tube and don't sit tight. Have considered grinding off part of the funnel to work, but haven't done so. In my load development over the last 6 years, I have had 2 squibs. Cranking out loads with the LockOut die, I have had no problems. Link to comment Share on other sites More sharing options...
jmorris Posted September 15, 2011 Share Posted September 15, 2011 In my case, it would be on a 1050. Again, GSI is the only bullet feeder that will feed and seat on the same station (except for the Lee) but they are only made for the 650 & 1050. Link to comment Share on other sites More sharing options...
jmorris Posted September 15, 2011 Share Posted September 15, 2011 I take that back. I recall Scarch selling a pneumatic feeder for the 1050 but that has been some time ago. Link to comment Share on other sites More sharing options...
TONY BARONE Posted September 15, 2011 Share Posted September 15, 2011 MA Systems sold an air operated bullet feeder for the Dillon RL-1000,CH and Star that fed the bullet at the seating station.I use it on my Star press and it works well. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now