Rounds always dropping out of side saddle

[lucas]

I tried the 7 shell with 2 pac 3 gun gear stuff,but shells kept falling out of my hard kicking benelli ,so i replaced it with a 6 shell plastic side saddle and now that is also dropping way to many rounds on the ground.for gun to work i have to use 3 3/4 dr loads.Could this be the problem?When i get my new bennelli thats being built ,it is supposed to work with 3 dr loads, i can only hope problem goes away.I knew the web stuff wore out,but not the plastic side saddles.

[Gary Stevens]

My Super 90 works just fine with 2 3/4 dram. Have you got one of the old M-1 Benelli's? They were set up to work with heavy loads.

[EricW]

Are you *sure* your Benelli won't work with less than a magnum goose load?

My cousin thought his Benelli would only run heavy duty stuff, but my homebrewed clays loads (about 3 -3 1/4dram) cycled his gun fine.

[Chris]

I saw one side saddle shell thingy where the guy put some screws in between the "fingers" that hold the shells. The screws push against the "finger" and all ow you to adjust the tension.

[benny hill]

make sure the shells are comming out the top side of the saddle. If they are not pushed in far enough , they will fall out.