I have the GMR-15 with the JP roll trigger. It takes a little getting used to but is reliable. I am at around 3.75lbs on the pull.
I recently build another PCC and used the Rise Armament A242 trigger. The trigger pull came in at 2.75lbs and is smooth. I managed to get it for $95 delivered with a free RA hat from Optics Planet It's been reliable and would definitely buy another again.
I think I prefer the RA trigger over the JP.
I was wondering if anyone has had a problem with using the Glock single stack 10 round mags in their JP PCC? JP told me that the bolt will rip into the follower if ran dry.
If there is an issue, is there a work around for it? The short Glock 26 mags are a pain when reloading.
I live in NJ, so there aren't many options.
Thanks for the help!
Rich
Hi!
Does anyone know if the JP barrel nut will slide over the JP comp for a 9mm JP light weight contoured barrel?
I want to replace the handguard with an Odin so as to lighten up my PCC.
Thanks for your help.
Rich
Thanks for the input and help.
I was actually looking to swap the same 5.23" length uppers, but in different calibers i.e. swap a TSO 9mm full upper for a TSO 40 S&W upper.
Is it just a matter of exchanging full uppers and that's it or is there something else that needs to be done.
Thanks.
I converted mine from a series 80 to 70, did a little trigger work, and changed the mag well to a Dan Wesson ss one for better weight and balance.
Managed to get the trigger below 3 lbs.
Lately, my 650 has been dropping 2 pieces of brass into the slide for station 1.
I cleaned the brass dropping mechanism, but it didn't solve the issue entirely.
This happens about 1 in 25 times now. It never happened in the 2+ years of reloading with the 650.
Any ideas or help is appreciated.
Thanks.
Rich
Will these Wilson 45 mags run if I use 40s in them?
http://gregcotellc.com/cart/1911-wilson-combat-magazines-c-150/wilson-combat-elite-tactical-1911-45-acp-10-rd-black-50045fs10b-p-1932.html
I am looking to use them in my Dan Wesson 40 for Limited 10.
Thanks.
Rich