je85 Posted April 6, 2017 Share Posted April 6, 2017 What does it take to make a Stock 3 9mm shoot 40s&w? Is switching calibers as easy as swapping the barrel, extractor, mag, and recoil spring? Is the 9mm and 40s&w breach face the same on tanfoglio slides? Link to comment Share on other sites More sharing options...
kneelingatlas Posted April 6, 2017 Share Posted April 6, 2017 From 9mm to .40 you will need a .40 slide as the 9mm breech face is too small, if you go .40 to 9mm you can get away with the same slide. Link to comment Share on other sites More sharing options...
IronArcher Posted April 6, 2017 Share Posted April 6, 2017 Barrel OD is the same?Sent from my iPhone using Tapatalk Pro Link to comment Share on other sites More sharing options...
lksyotas Posted April 7, 2017 Share Posted April 7, 2017 (edited) Yes, the barrel OD is the same between the .40 and 9mm. I swapped over a Stock 3 9mm barrel into my Lim Pro .40 cal upper and it worked fine. Although you might run into issues with the extractor and proper tension on the rim of the case. In my case it worked fine but some report that you would need to stone or file a few thou off of the extractor flat to allow it to index further into the breech to grip the 9mm properly. Also, my 9mm mags functioned fine with the .40 rounds I was testing. The feed lips are close in width but shorter on the .40 mags. Edited April 7, 2017 by lksyotas Link to comment Share on other sites More sharing options...
je85 Posted April 7, 2017 Author Share Posted April 7, 2017 So a .40 slide will work with a 9mm barrel? A 9mm slide wont work with .40 barrel? I would have no problem tuning extractors. Link to comment Share on other sites More sharing options...
IronArcher Posted April 7, 2017 Share Posted April 7, 2017 So, theoretically, you could have a 9mm barrel cut to .357 SIG, and drop it in a 40 slide,and be ready to rock? Sent from my iPhone using Tapatalk Pro Link to comment Share on other sites More sharing options...
TonyRumore Posted April 14, 2017 Share Posted April 14, 2017 (edited) Yes. Edited April 14, 2017 by TonyRumore Link to comment Share on other sites More sharing options...
IronArcher Posted April 15, 2017 Share Posted April 15, 2017 Awesome!Sent from my iPhone using Tapatalk Pro Link to comment Share on other sites More sharing options...
johnbu Posted April 15, 2017 Share Posted April 15, 2017 On 04/07/2017 at 11:45 AM, IronArcher said: So, theoretically, you could have a 9mm barrel cut to .357 SIG, and drop it in a 40 slide,and be ready to rock? Sent from my iPhone using Tapatalk Pro But... Why? 9mm brass is too cheap and plentiful? Capacity too high ? 357 sig... what's the point? Link to comment Share on other sites More sharing options...
walrus76 Posted April 30, 2017 Share Posted April 30, 2017 Where can I get a 40 slide? Link to comment Share on other sites More sharing options...
bpipe95 Posted May 1, 2017 Share Posted May 1, 2017 EAA Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now