Caliber conv. chart for 1050 ?

[wombat]

The aluminum bullet tray is optional. The super 1050 comes standard with the plastic bullet bin.

Guess he didn't buy it from benos....

I did get it from Brian.

So I asked this in another thread but this one gets more traffic so I will ask it again here. Is there a caliber conversion list for the 1050 any where? There is this http://www.brianenos.com/forums/index.php?showtopic=11064 but it does not cover the 1050. I have a new 1050 in .223 and possibly want to load .40 s&w on it. It seems like I would not need that many different parts and most would be for the case feeder.

[Flexmoney]

I split your question out and gave you your own thread. It should work better than tagging on to a thread on a different topic.

-Admin.

[dillon]

See pages 24 & 25 in the instruction manual.

[wombat]

See pages 24 & 25 in the instruction manual.

I have seen that but it is unclear to me.

From page 24 for .40 S&W

12940 #W Shellplate

14062 #2 Locator Buttons (6)

12912 10mm cal. Expander – W

13878 Adapter – Green

13098 Casefeed Plunger – Medium

17384 Blue Locator Tab – Short (1)

13569 Blue Locator Tab (5)

14067 Die Lock Ring

13005 Powder Activator – Pistol

Do you need the 10mm expander, can I not just use an expander die? Does the same powder bar work with both .223 and .40 powder charges? I do not see priming parts on that list or swager parts but they are the same for .40 and .223. Is the 13878 adapter for the case feeder? What is the die lock ring for? I would also need a casefeed plate too, wouldn't I? Are any more parts needed for the casefeed change over?

[benos]

See pages 24 & 25 in the instruction manual.

I have seen that but it is unclear to me.

From page 24 for .40 S&W

12940 #W Shellplate

14062 #2 Locator Buttons (6)

12912 10mm cal. Expander – W

13878 Adapter – Green

13098 Casefeed Plunger – Medium

17384 Blue Locator Tab – Short (1)

13569 Blue Locator Tab (5)

14067 Die Lock Ring

13005 Powder Activator – Pistol

Do you need the 10mm expander, can I not just use an expander die? Does the same powder bar work with both .223 and .40 powder charges? I do not see priming parts on that list or swager parts but they are the same for .40 and .223. Is the 13878 adapter for the case feeder? What is the die lock ring for? I would also need a casefeed plate too, wouldn't I? Are any more parts needed for the casefeed change over?

Call me tomorrow or whenever you can. I could explain it better/easier than typing it.

Thank you,

Brian

toll-free: (877) 219-5598