cpty1 Posted December 13, 2005 Share Posted December 13, 2005 Anybody found a good way to polish Tec Loaders short of a dremel? Picked up some new ones and they don't work very smoothly. Handle binds in the tube at times. Link to comment Share on other sites More sharing options...
George Posted December 13, 2005 Share Posted December 13, 2005 Try some powdered graphite until they get broken in. Link to comment Share on other sites More sharing options...
n2ipsc Posted December 13, 2005 Share Posted December 13, 2005 Try some powdered graphite until they get broken in. Something else that works well is swabbing the inside of the tubes with silicone spray (keep one of those 12ga shotgun plush cleaning "wands" - sprayed down with silicone - in a plastic bag in your kit)... Link to comment Share on other sites More sharing options...
cking Posted December 13, 2005 Share Posted December 13, 2005 The edges of the tube slit are sharp, easy to cut fingers on also. Just take some sand paper and knock the edge off. I use car wax on them to slick them up and not attract dirt. Works good on regular mags also. Link to comment Share on other sites More sharing options...
Chriss Grube Posted December 13, 2005 Share Posted December 13, 2005 Try a new concept and practice with them, they'll be fine after about 10-15 reloads. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now