Squirrel45 Posted May 16, 2022 Share Posted May 16, 2022 Hi Everyone, Im currently trying to figure out my 625 PC 4" (again) with iron sights. I shoot this gun for a couple of years with an optic but looking to now use it for limited 6 in ICORE. Any who, I installed a Hi-Viz .250" front sight but can only see about half of the fiber, the other half gets cut off buy the sight. I was told by a friend to file down the notch but its almost down to the mount now . Currently it has a .100" rear sight with a .70" notch. What rear sight sight blade should I be looking for .160" so I can file it out? thanks Squirrel Link to comment Share on other sites More sharing options...
GMM50 Posted May 17, 2022 Share Posted May 17, 2022 This might help. https://www.revolversupply.com/sight-adjustments/ Link to comment Share on other sites More sharing options...
ysrracer Posted May 17, 2022 Share Posted May 17, 2022 (edited) .196 is what I use. https://www.midwayusa.com/product/1004507628?pid=750428 . Edited May 17, 2022 by ysrracer Link to comment Share on other sites More sharing options...
pskys2 Posted May 17, 2022 Share Posted May 17, 2022 11 hours ago, ysrracer said: .196 is what I use. https://www.midwayusa.com/product/1004507628?pid=750428 . If you get just the blade, you have to get the nut and windage screw. It's not a hard install. https://www.midwayusa.com/product/1004510531?pid=770146 https://www.midwayusa.com/product/1004496668?pid=672392 Procedure is to tighten the old screw until it breaks, then install the new stuff (don't lose the detente though, install and using a center punch carefully punch the left end of the new screw. That crimps it to the new nut. Or you can buy the whole assembly https://www.midwayusa.com/product/1004431882?pid=242918 Brownells also carries them. Once you do this you "may" have to change FS again. Though my 4" Pro works ok with a .250 high FS. Either way you need the RS blade notch to be at least .08" deep. Link to comment Share on other sites More sharing options...
Squirrel45 Posted May 19, 2022 Author Share Posted May 19, 2022 On 5/17/2022 at 10:43 AM, pskys2 said: If you get just the blade, you have to get the nut and windage screw. It's not a hard install. https://www.midwayusa.com/product/1004510531?pid=770146 https://www.midwayusa.com/product/1004496668?pid=672392 Procedure is to tighten the old screw until it breaks, then install the new stuff (don't lose the detente though, install and using a center punch carefully punch the left end of the new screw. That crimps it to the new nut. Or you can buy the whole assembly https://www.midwayusa.com/product/1004431882?pid=242918 Brownells also carries them. Once you do this you "may" have to change FS again. Though my 4" Pro works ok with a .250 high FS. Either way you need the RS blade notch to be at least .08" deep. Thanks for the insight Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now