DMZ85 Posted May 16, 2022 Share Posted May 16, 2022 I loaded about 1000 rounds of 9mm too long for the PCC that they are intended for. Any thoughts running the rounds through my XL750 to decrease the overall length by around 1mm. They have been crimped by a Lee factory crimp die. Thanks. Link to comment Share on other sites More sharing options...
Rnlinebacker Posted May 16, 2022 Share Posted May 16, 2022 Done it. You're fine. Just gonna be a while loading then into seating die one at a time Link to comment Share on other sites More sharing options...
ddc Posted May 16, 2022 Share Posted May 16, 2022 8 hours ago, DMZ85 said: I loaded about 1000 rounds of 9mm too long for the PCC that they are intended for. Any thoughts running the rounds through my XL750 to decrease the overall length by around 1mm. They have been crimped by a Lee factory crimp die. Thanks. I have done it to fix minor length discrepancies on the order of 0.005. 1mm seems like a lot. Almost 0.040. Are these rounds that were intended to be shorter and had been tested at that shorter length? They were just loaded longer by mistake? If so then you would be ok. If that shorter length has never been verified with that load then it is too much. Link to comment Share on other sites More sharing options...
OptimiStick Posted May 23, 2022 Share Posted May 23, 2022 I've done it more than once. Just feeding it into the seating station and then letting it run thru crimp again also, though I don't know that that crimp did anything. It was just easier to do it that way. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now