How to modify the Sig MPX telescoping stock

[cworks]

Before I ruin my stock....

 

My goal is to make the telescoping stock a single pull to the full open position.  Who even uses the first (middle/half open) position. It’s pretty annoying having to press the button the releases the stock to slide open twice in my opinion. So my question is, is It possible or has anyone ground the first notch to allow the stock to bypass that position? 

Edited April 13, 2020 by cworks

[Nathanb]

I think I’d try to fill the notch first with something that could be heated and removed if you changed your mind or ever wanted to sell. 

[cworks]

That would work too. 

[rlamantea]

Try some JB (quick) weld and fill in the notch.  Hard to guess how long it will last but it should be easy enough to chip out if you want to remove it.  Clean the notch, put the JB quick weld in the slot, wrap tightly with some tape, wait 5 mins and clean up the outside when the tape is removed.  Easy to put back to stock.

 

Best of luck