Need a measurement on SV steel grip

[Broncman]

Trying to fit my E2 grip to a Racer holster and the E2 front trigger guard strap is thinner than a STI plastic. They offer an SV insert.

Can anyone measure their SV at the thinnest part of the curve on the front of the trigger guard for me?

Trying to eliminate that gap.

 

[schaet]

I have an E2 and the Alpha X holster and had to use the SV/STL block on it as the STI block fit was sloppy.

BTW the SV/STL block fits perfectly.

I'm not sure of the Racer is the same, but I would tend to think it would be.

I hope this helps.

Sent from my XT1650 using Tapatalk

[arkadi]

SV is 4mm.

[amccallister]

I got .151”at the thinnest part, and about .351” wide.

[Broncman]

Thanks! Little smaller than STI and bigger than E2.