Any trick to stiffen the safety on a Stock 2?

[IHAVEGAS]

Gooberd a gun on table start yesterday and subsequently somehow ended up bumping the safety on and blowing a stage.

 

With CZ's I use DSPerman extra power safety springs to help prevent such things. Is there anything you can do to stiffen the safety with a Tanfo without breaking USPSA production rules? 

[Tanfastic]

Put the low-profile standard safety lever in instead of the extended one that came in the Stock 2, at least it makes it less likely you'll hit it accidentally.

[CarlB86]

Unica flush safety or some adhesive under the safety to build up some friction on the frame surface. Safety can still engage, but has a lot of drag.

[01Deuce]

Assuming you still have the ambi - saftey installed  here is what I have done. 

  Remove the ambi side. Cut out a piece of plastic like from a check book register ( the thing we used to pay are bills with) or something that is flexible  and a decent thickness. Make a hole to fit over the saftey shaft and put the ambi paddle back on. What you want is something thick enough so it pulls the shaft tight and still allows you to insert the roll pin. I initially did this to take the play out of the ambi side, but it pulls the other side tight and creates more resistance.