Gen 2 Trigger Bar Bolo Mod

[SoCalShooter69]

Gents; here is a quick guide if you receive your Tanfo with a Gen 2 trigger bar, and you've ordered a bolo/titan/1-piece sear.  You'll only need to remove .020", so go slow and measure often. It doesn't take much using a rotary and diamond bit. 

 

 

 

[Sc0]

What does this .020" removal accomplish?

Edited August 20, 2017 by Sc0

[SouperMan]

What does this .020" removal accomplish?

The new trigger bars are causing reset issues with Gen 2 Bolos. Relieving the .020" accounts for the height/dimensions of the new trigger bar which should help reset for Tanfos with the newer trigger bar and a Gen 2 Bolo.

[SoCalShooter69]

11 hours ago, SouperMan said:

 

The new trigger bars are causing reset issues with Gen 2 Bolos. Relieving the .020" accounts for the height/dimensions of the new trigger bar which should help reset for Tanfos with the newer trigger bar and a Gen 2 Bolo.
 

 

 

The bolo won't actually sit down on the trigger bar enough to function in DA.

 

A very simple mod if you have a Gen 2 trigger bar. Email or call the shop with any questions or concerns. 

Edited August 23, 2017 by SoCalShooter69

[SoCalShooter69]

Bumping this since we've been getting a lot of inquires about the gen 2/bolo fitment. 

 

We will mod from the shop of you request, but we've had 100% success with customers able to do this at home, following the video guidelines. The .020" seems to be the sweet spot. We've sent some blind to customers in Europe and South Africa, and they've dropped right in.

 

As always, call or email the shop if you have any questions or issues. 

 

Thanks!

Edited October 15, 2017 by SoCalShooter69