NacsMXer Posted August 9, 2017 Share Posted August 9, 2017 I'm right handed and the wide thumb safety on my Limited digs into my support hand thumb knuckle while shooting. I already bobbed the front 90 degree corner of the safety to a 45, and generously beveled the entire sharp bottom edge of the safety with a needle file. It still digs into my knuckle while shooting with a good high support hand grip. I'd like to have my safety reshaped similar to the next few photos. This is Tony Pignato's Limited. He told me he did it on a grinder wheel. I don't trust myself to not slip or seriously botch the job on a grinder wheel. Could you guys recommend someone I could send my safety to, to have done? Would J&L gunsmithing be able to do this mod for me? Thanks.upload your photo Link to comment Share on other sites More sharing options...
waktasz Posted August 9, 2017 Share Posted August 9, 2017 I'm sure you have a buddy somewhere with a dremel and somewhat steady hands Link to comment Share on other sites More sharing options...
MemphisMechanic Posted August 9, 2017 Share Posted August 9, 2017 Send it to me and I'll do it. That's a ten minute job. Link to comment Share on other sites More sharing options...
NoKimberDave Posted August 10, 2017 Share Posted August 10, 2017 Reminds me of the CZC TS safety. I wish the whole blade was 1/4" higher! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now