Smooth out frame where disconector moves (Tanfo/CZ)

[e-mishka]

I need to smooth/polish out frame where disconector moves back and forth in da mode. I tried using dremmel with sand paper drum attachment but it hard to reach.

What tool do you guys recommend?

Here is attached pic of area that need smoothing out.

[bikerburgess]

I have done it with a piece of increasingly fine sand paper on a piece of wood I cut to fit the notch and I have done it with a bullet point polishing bob on a dremmel I think the sand paper worked better as it left the surface flatter but both worked pretty well.

[kneelingatlas]

I use my finger with a little piece of sandpaper.

[Silver_Surfer]

I'd wrap fine sandpaper around a chopstick and polish it.

[e-mishka]

I was hopping there is some magic tool so i'd be done in 10 min, but I guess its gonna be a lot of manual labor

[manolis]

I was hopping there is some magic tool so i'd be done in 10 min, but I guess its gonna be a lot of manual labor

Maybe this solution is "magic"

http://www.czfirearms.us/index.php?topic=42537.15 replay#16