je4134 Posted March 29, 2013 Share Posted March 29, 2013 The only primers I have been able to find locally in months is Winchester Small Pistol Magnum primers. How will these work in a striker-fire pistol? Are they too hard? I'm shooting a Springfield XDM with N320 powder, 4.7g, enough to make major power factor. Any input is welcomed. Thanks. Link to comment Share on other sites More sharing options...
Alaskapopo Posted March 29, 2013 Share Posted March 29, 2013 Reduce you load by about 10% and test a small batch but they should be fine with your XD. Pat Link to comment Share on other sites More sharing options...
motosapiens Posted March 29, 2013 Share Posted March 29, 2013 i shot a couple thousand of them over the last few months. I didn't notice any difference in hardness (shot out of a cz75 with 13lb mainspring). I didn't change my load at all, but I'm shooting minor. Link to comment Share on other sites More sharing options...
xracer Posted March 29, 2013 Share Posted March 29, 2013 I've shot a few hundred through my M&P 9C with no issues, didn't change my load either since I'm not really close to max. Link to comment Share on other sites More sharing options...
MesaAndy Posted March 29, 2013 Share Posted March 29, 2013 They work fine, as do small rifle as long as they go off. Stay away from Wolf small rifle, the cup is too hard for a pistol to set off usually. Stick to the Min loads or as said earlier, drop you load by 10% for magnum primers. Don't use small pistol in rifle ever. Large rifle and pistol are different heights, don't sub those. Link to comment Share on other sites More sharing options...
Justsomeguy Posted April 2, 2013 Share Posted April 2, 2013 The only difference between small pistol and small pistol magnum primers is the amount of compound in the cup. The hardness of the cup is the same, but magnum primers have a bit more compound to increase the length of the spark so as to better light up the slower powders in a longer column generally used in magnum pistol loads. As advised by Alaskapopo, you should reduce your loads by a few 10ths of a grain to allow for more of the powder being lit up more quickly with the magnum primer and thus raising pressure somewhat. This is more important the closer you are to max loadings with a particular powder. Link to comment Share on other sites More sharing options...
Croomrider Posted April 4, 2013 Share Posted April 4, 2013 I have found very little difference in velocity when changing between small pistol, small rifle, and small pistol magnum primers. I don't think the magnum primers are much if any hotter than regular primers, but I do believe they add some compounds to make them ignite some powders a little better. Mike Link to comment Share on other sites More sharing options...
ramairthree Posted April 5, 2013 Share Posted April 5, 2013 I get an average 20 fps bump with same powder, same bullets, same pistol. No signs of pressure. But I am only a mid range 40 loader. I have 10mm if I want to go whole hog. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now